Skip to content

Activity

Activity 1

Configure DHCP on a Wireless Router using Cisco Packet Tracer.

  • Go to Classes ICT.
  • Open the file 1. configure-dhcp-on-a-wireless-router.pka.
  • Follow the instructions.

Info

In this activity, you will complete the following objectives:

  • Connect 3 PCs to a wireless router.
  • Change the DHCP setting to a specific network range.
  • Configure the clients to obtain their address via DHCP.

Activity 2

Examine NAT on a Wireless Router using Cisco Packet Tracer.

  • Go to Classes ICT.
  • Open the file 2. examine-nat-on-a-wireless-router.pka.
  • Follow the instructions.

Info

In this activity, you will complete the following objectives:

  • Examine NAT configuration on a wireless router.
  • Set up 4 PCs to connect to a wireless router using DHCP.
  • Examine traffic that crosses the network using NAT.

Activity 3

Identify MAC and IP Addresses using Cisco Packet Tracer.

  • Go to Classes ICT.
  • Open the file 3. identify-mac-and-ip-addresses.pka.
  • Follow the instructions.

Info

In this activity, you will complete the following objectives:

  • Gather PDU Information for Local Network Communication
  • Gather PDU Information for Remote Network Communication

This activity is optimized for viewing PDUs. The devices are already configured. You will gather PDU information in simulation mode and answer a series of questions about the data you collect.

Activity 4

Observe Traffic Flow in a Routed Network.

  • Go to Classes ICT.
  • Open the file 4. observe-traffic-flow-in-a-routed-network.pka.
  • Follow the instructions.

Info

In this activity, you will complete the following objectives:

  • Part 1: Observe Traffic Flow in an Unrouted LAN
  • Part 2: Reconfigure the Network to Route Between LANs
  • Part 3: Observe Traffic Flow in the Routed Network

Activity 5

Create a LAN.

  • Go to Classes ICT.
  • Open the file 5. create-lan.pka.
  • Follow the instructions.

Info

In this activity, you will complete the following objectives:

  • Connect Network Devices and Hosts
  • Configure Devices with IPv4 Addressing
  • Verify the End Device Configuration and Connectivity
  • Use Networking Commands to View Host Information